Maniaplanet Forum

when i use the admin command to add maps to the server /admin add [MXcode] it doesnt return anything? while if i type /admin add [nothing] it returns "that's no a valid MX code" or smth close too ?

Are you in the Admin or MasterAdmin group?

masteradmin

Just added a map with "/admin add 121209":


Maybe you tried to add a map which doesn't fit into the dedicated server. You should check the dedicated server logfile if you can find a message that a map was denied. That's a problem I already had reported (I think years ago) but it's not changed yet. The dedicated server rejects sometimes maps and does not response well on method CheckMapForCurrentServerParams.

If you find something please post that logfile and the link to the map so I can report that.

Hi
I'm newbie and i have just created a new server running uaseco (with serverhost nc1.eu)
Everything works fine so far, except i cant figure out /admin add. From the log:



How to fix this?

btw, thx for your work Undef!

oldkami wrote: ↑27 May 2017, 12:17 Hi
I'm newbie and i have just created a new server running uaseco (with serverhost nc1.eu)
Everything works fine so far, except i cant figure out /admin add. From the log:

How to fix this?

You can't, that's a part for your hoster.

But if you can access the php.ini which is used from your PHP-CLI, then you have to enabled the extension "php_openssl.dll" like this:

extension=php_openssl.dll

... but I think you can't.

Ok, thanks for info. I will send a request to my serverprovider.
Thanks again