Page 1 of 1
Rotate blocks verticaly ?
Posted: 30 Aug 2011, 12:32
by d.m.f._nl_
Is it possible to make it so in the editor to rotate blocks verticaly.
It would be nice for example to have a vertical finish and stuff, think that would be nice
( or at least make start and finish as a vertical block, opens a lot of possibilities )
( when my English is not correct, then at least try to get the message )
Re: Rotate blocks verticaly ?
Posted: 30 Aug 2011, 12:56
by fabian26
That's an good idea, I had the same idea, but in the german Forum.
That's also good for making real racing circuits, because they haven't only straights and 90 degrees curves.
Re: Rotate blocks verticaly ?
Posted: 04 Sep 2011, 15:12
by b.dnl
-1 Dont you want to create your own blocks? ...
Re: Rotate blocks verticaly ?
Posted: 13 Sep 2011, 15:37
by d.m.f._nl_
b.dnl wrote:-1 Dont you want to create your own blocks? ...
Sure i want to, but i am not that good ( even with explanation )
So i only want to rotate blocks vertical instead of only around its horizontal axes.
Re: Rotate blocks verticaly ?
Posted: 13 Sep 2011, 15:47
by metoxys
Upside down blocks. Shiiiiiit. ... Upside down finishes for loopings! Yaaaaay!
Re: Rotate blocks verticaly ?
Posted: 14 Sep 2011, 13:06
by d.m.f._nl_
metoxys wrote:Upside down blocks. Shiiiiiit. ... Upside down finishes for loopings! Yaaaaay!
See the posibillities are endless then Yeah
Re: Rotate blocks verticaly ?
Posted: 16 Sep 2011, 11:33
by Fijut
being able to rotate blocks on all axis' would be nice
also, being able to mirror blocks would be very convenient