Hello, Sorry for the late answer, i definetly won't get notifications... And thanks for yours. I will try the Void Block trick. I though it could not work because i always see roads as Race Road, from which you can't delete the structure. I never use the "small" roads, because i'm too bad ...

Hi, The way the Scale tool gizmo can be partially hidden by surrounding geometry often drives me crazy... It happens when you scale a mesh part and you must then get the camera inside the geometry in hope to find your handle and be able to grab it (but then being unable to see what scaling you're do...

Yes, this does work with "blocks", but not with "items", even if created from standard blocks. The mesh i'm doing can't be a block, because even if i use the standard road mesh, i must get rid of the structures around ( the concrete ramps on each sides, particularly, for every gr...

Hi,
Well, all is in the title...
I have created ground level items, but once shadows calculated, vegetation is going through... (In the desert, haha...)
So my brand new and shiny item looks like an old abandonned piece of concrete and bitumen.

Ok, not a big deal, but is there a way to avoid this ?

Ok... Thanks TMarc.
I didn't find any way neither. Too bad, it sometimes could be useful.

Sorry for the delay, for some reason i don't receive notifications about replies.

Hi Eyebo,

I've asked in another topic about how to setup the rotation's step to something else than 10°, but got no response...
I've tried many ways but can't find out how to rotate by 5° or 1° or even freely, as for the Rotation Tool.
Any clue ?

No, i'm actually speaking about the Spline Tool, next to Create Face / Create Segment in the Tool Bar. But i've read in another forum that it is broken, or rather unfinished, since 3 years... Too bad, could be a great tool to create complex or smooth shapes. Thanks anyway, TMarc. By the way, i've as...

Well, almost 3 years later... and it's still broken.
Not a rant or a blame, just a regret.

Hello,

Question is in the title... I can't find a way to rotate it by smaller increment. I've tried to set the rotation tool to 1 or even 0° before going to the deformation tool, but it doesn't seem to have any effect. Stucked on 10.

A trick ?

Hello, I could make good use of a spline if it worked like in 3d softwares, but here i can't figure out how this tool works. I create a spline and end up with handle's point, and that's it. No way to manipulate or even see the spline, not speaking about extruding it to make a shape... I must miss so...