Page 6 of 6
Re: Full X360 Controller Support
Posted: 13 Sep 2011, 13:59
by Neox94
StinkFinger wrote:Mapping accelerate on the right trigger, and B for brake. When holding accelerate down and pressing the brake, the acceleration stops, and I have to lift and re-press the trigger before it accelerates again. Controller is fully calibrated and works as expected in the game controller config screen in Windows.
Windows 7 64-bit
XInput driver: 2.1.0.1349
I have the same problem for my ps3 controller too.
Now I just play with
X: Accelerate
R1: Brake
Realy good with this
Re: Full X360 Controller Support
Posted: 16 Sep 2011, 16:54
by kruxed
Xymph wrote:kruxed wrote:Is there no dead zone and sensitivity options or am i being blind?
Esc -> Advanced Options -> Input Settings.
forgot to reply
cheers, seems strange you have to be in a match to tweak the controls in this way
Re: Full X360 Controller Support
Posted: 16 Sep 2011, 18:23
by Xymph
kruxed wrote:Xymph wrote:kruxed wrote:Is there no dead zone and sensitivity options or am i being blind?
Esc -> Advanced Options -> Input Settings.
cheers, seems strange you have to be in a match to tweak the controls in this way
Not really, then you can experience the changes in settings immediately. And you can also change them in solo mode, Esc -> Input Settings.
Re: Full X360 Controller Support
Posted: 16 Sep 2011, 20:20
by RichardRobertson
I also ran into the "where is the deadzone config" thing. I already knew that 30% deadzone works best on my controller (.15 in TM2) but I couldn't find where to enter it until I asked somewhere else.